Page 1 of 1

Print in landscape mode - is it possible?

PostPosted: Tue Feb 09, 2010 4:58 pm
by talter
Hi,

I'm programming in VBA (AutoCAD) and would like to know how I can generate my PDFs in landscape vs. portrait layout.

This is possible when plotting manually using the driver. However, when using an automated interface, the output is always in portrait mode.

I've seen several other posts about this same issue, but no responses. Will it be possible for someone from development to answer whether it is possible to specify a landscape output when controlling Bullzip programatically?

Thanks in advance for your help.

Re: Print in landscape mode - is it possible?

PostPosted: Fri Mar 05, 2010 9:15 am
by calieigh
According to page 39 (49 in PDF) of the manual, the minimum bottom margin (or right margin when printing in landscape mode is 14.2 mm when printing letter paper. If you specify photo paper you can print to 0.12" at the bottom (right) margin.